NEWS
Oil Based Drilling Cuttings Treatment Equipment for Russia Client
This week, GN shipped out 2 set cutting treatment equipment to Russia for the project to recover the drilling fluids from oil based drilling cuttings. With consideration of the weather, the equipment is installed in the container; this design will make the transportation easier as well.
Drilling cuttings equipment is the main equipment in the closed loop mud system; it can recover more valuable drilling fluids and reduce the waste discharge. Drilling cost will be reduced and environment is protected.
Tank Bottom Oil Sludge Treatment Equipment for Guangdong Client
Tank bottom oil sludge is a kind of waste mixture of oil, water and sand. However, if the oil and water could be recovered from the sludge, a great benefit would be obtained. This week, GN will finish the factory trail assembling and test for one set of oil sludge treatment system for an oil storage tank bottom cleaning project.
Working Principle of GN Oil Sludge Treatment System
GN oil sludge treatment system is using a series of equipment to separate the oil, water and solid step by step; while in each specific procedure, the separation equipment will be different.
GN Big Bowl Decanter Centrifuge and Shale Shakers for USA Client
GN is known as one of the solution provider especially for solids and liquid. One batch of solids control equipment was ready for shipping to a USA client who is doing the solids control business. The equipment included in this order is shale shakers and decanter centrifuge.
Shale shaker and decanter centrifuge are two type solids control equipment with different working principle. The shale shaker separates the solids by using the wire mesh based on the solids size, while the decanter centrifuge separates the solids using the centrifugal force. Shale shaker is almost used for the coarse solids separation, and the decanter centrifuge is used for fine solids separation. Thus is the step by step separation system, the decanter centrifuge is always located after the shale shaker.
Drilling Mud Recycling System Ready for Shipping to Domestic Client
With many years' experience, GN is able to design and manufacture the mud recycling system either per standard configuration or clients' requirements. This week, one set solids control system will be completed the factory trial assembling and test, then shipped out to a China domestic drilling company.
1500 HP Oil Drilling Rig Solids Control System for India Client
One set solids control system for 1500HP oil drilling rig is now in the final assembling procedure. After the factory trial assembling job is completed, water test will be done on the system to check if any leakage problems. India is one of the main markets for GN Solids Control, now many GN equipment and system are running there.
