GN solids control is equipment manufacturer and package system solution company
It’s a most technique used in a drilling rig to separate the solids part in the drilling fluids that are crushed by the drill bits and carried from well surface. Normally, normally one solid control system contains five stages: shale shaker/vacuum degasser/desander/desilter/centrifuge,and most equipment install in top of mud tank
Most engineer will call mud system as 4 phases solids control process or the 5 phase purification system. like shale shaker, vacuum degasser, to Desander cone, Desilter cone, and the decanter centrifuge. Based on different working principle and separation point. The well drilling will request this system to process drilling fluid. but, with different well depth and drilling condition the system designer need make different configuration and different result.
Solids control is most use in oil and gas drilling,but for request of separation,more and more industry plan to use it
1.Separate big partical and impurities from drilling fluid,to clean it and recycling use,to save keep less cost,and less discharge,for better environment,normally will use shale shaker/degasser/decanter centrifuge/desander/desilter/related pump and mixer
2.In some river clean project,need remove dirty mud from river water,decanter centrifuge will be good choice to control solids part from 2-5μm
3.When meet mining job,solids control will give support by separate and recycling,it will request shale shaker and decanter centrifuge mostly
4.Some dewatering system will need decanter centrifuge to treat polymer,to make better solids control
5.Few builing company are trying use solids control to reuse water and material,avoid un necessary cost
6.Liquid food area will request decanter centrifuge to raise quality,we supply solution too
GN solids control welcome all separation request,and give best solution