Jun 17

Mud Agitator is one of the solids control equipment that is mainly used to mix the drilling fluids in the mud tanks to keep the solids inside the drilling fluids suspending other than sedimentation down to the tank bottom.
GN’s sales team ever received many inquiries on the mud agitators; unfortunately, most of the clients have no idea on how to choose the right model for their project and even don’t know how to use the equipment properly to ensure a longer life time.

gn-mud-agitator

Drilling Mud Agitator

GN’s sales are good at understanding clients’ specific request by asking few simple questions. With the answer from the clients, GN always could give the best proposal for clients. Now let’s see what these questions are and what information GN need to give a proposal.
a. What is the inside dimension of the mud tank or pit. From this question, GN will know the inside length, width and depth of the mud tank, and then GN will know how long the agitator shaft should be suggested for clients and how big impeller should be used. For the deep mud tank or pit, the stabilizer will be provided to hold the agitator shaft for stable performance.
b. What is the shape of the mud tank, cylinder or rectangular? Then GN will know how to design the agitator.
c. What is the electric specification, mainly GN would like to know the jobsite electric voltage and frequency. Different countries may have different frequency, the 50 Hz motor cannot be used under 60 Hz, and safety is ever the first think we should keep in mind.
d. What is the S.G. of the liquid? For very thick liquid, GN will propose bigger horse power motor to drive the agitator.
Mud agitator is always installed in mixing tank with jet mixing unit, active mud reserve tank and trip tank. For some clients who get the mud agitators from GN and make the mud tank by themselves, GN always recommends them to make the mud tank with same dimension, thus they can get the agitator all same model, which would be much better for clients’ future maintenance. GN suggest the RPM setting of the mud agitator between 40-96, too high will disturb the solids suspending, while too low will lead to solids sedimentation.

written by admin \\ tags: , , ,


Leave a Reply