NEWS

May 09 2019

This week, GN showed at the OTC once again. The OTC is really a good plat for people from petroleum industry come together to communicate on new technologies and ideas. Being a solids control equipment equipment manufacturer, every year, GN Solids Control will meet with old customers at the OTC, and get acquainted with new visitors. This year, GN booths were focused by lots of visitors as usual. This week, GN showed at the OTC once again. The OTC is really a good plat for people from petroleum industry come together to communicate new technologies and ideas. Being an equipment manufacturer, every year, GN Solids Control will meet with old customers at the OTC, and get acquainted with new visitors. This year, GN booths were focused by lots of visitors as usual. 

GN is with rich experience in design and manufacturing the solids control equipment like drilling fluids shale shaker, shaker screen and decanter centrifuge. Moreover, GN is investing a lot in research and development so that to provide better solution to customers. This year, besides the shaker unit and decanter, GN also brought few new items to the show. 

GN Sludge / Solids Vacuum Pump

GN sludge vacuum pump is a kind of pneumatically pump that could be widely used in transferring high solids content material. Liquid, slurry, wet sludge and even dry solid powder could be pumped by using this machine. Specifically, this vacuum pump could be used to transfer drilling cuttings discharged from primary shale shaker to subsequent cuttings drying machine. The drilling waste in the pit, after long time accumulation, with high viscosity and solid content, can also be conveyed by this pump. It is 100% air drive, and no moving parts in the vacuum cavity, therefore, this pump could be used in explosion-proof area without involving the electrical parts to prevent the sparking. 

GN ViST Vacuum Screen System

GN ViST vacuum screen system is working together with shale shaker. By installing a collecting pan under the last panel shaker screen, the drilling fluids could be vacuum sucked into a vacuum unit to increase the fluids recovery rate. It is suitable for all types drilling mud like OBM, WBM and SBM. In the meanwhile of recovery fluids, the drilling waste discharge is greatly reduced, and the cost in transporting the waste will be saved. With one set GN VIST vacuum shaker screen system on drilling site, the driller can fit finer screens on the shaker to separate much finer cuttings and save the cost in placing extra cuttings drying machine.

Visitors always find new things at GN booth at OTC. For more information, welcome to contact GN Solids Control.